The ***ALL NEW*** AUSubaru.com.au Forums

I was using a rattle gun with a non impact uni joint. Socket came off the bolt, uni turned 90 degree and fired the socket into my head at high speed. I was knocked out for about 30 seconds the boys at work recon.

Take the oil pump off and fill it with grease. Just wheel bearing grease should be ok. When I works at a suberu dealer as a mechanic we use to rebuild ea81s on a change over and thats what we did to them all. Some would sit around for months before being sold. We never had a problem getting oil pres...

I fitted one then got it registered and had no problems with a roadworthy cert. or reg, go for it you wont regret it.

The XT seats are not easy to fit. I had to make and weld adapter plates to the XT mount then bolted it to the brumby runners. The seats are a bit too high but as I am fairly short its ok and it gives good vision when offroad. The gearshift boot was just off the shelf from autobarm, I cant remember t...

motor mechanic

I fitted forester XT seats to my brumby. Had to do a far bit of fabrication to get them to fit. They are a bit to high as well, for me is ok as I m a short ass. Got them from ebay $300 for both.

For spray painting you should get one that is rated at 12 cfpm or better.

Yes we went by ourselves, I have a tirfor winch to get us out of trouble. You would need a lifted liberty to go the way we when but I think if you go through Mansfield and turn off half way up mount buller on to I think its called to circuit road you would make it easy. As long as the weather has be...

Sounds good, there are not to many of us subaru offroaders in victoria.

Another blue one I hope.

I am a fan of the colour too.

The seats are from a xt forester and the wheels are 14 inch ROH wheels with nankang tyres.

Has anyone tried to redrill there hubs as in this ad I saw on ebay.
Doesnt look to legal to me.

http://cgi.ebay.com.au/Subaru-leone-5-s ... dZViewItem

I payed $120 fitted each in northeast victoria

Or you could try this one also.


http://www.miata.net/garage/tirecalc.html

Heres some more

Took my brumby on its first proper trip over the week end since finishing it late last year. Have dont a few small runs but this was the first major trip. Went up the king valley and up to craigs hut which has only just been rebuilt after being burnt down in Dec 2006.There were some quite difficult ...

You can use the L series prop shaft. I made a mount for the centre bearing and have had no problems over the last 6 months its been in there.

Will a L series bull bar fit a brumby?

I think theres a subaxtreme bar on ebay at the moment for a gen3 outback
$600

When i did my mechanic apprenticeship at a subaru dealership at the time of the release of the series 1 libery we had problems right from the start with wind noise around the mirrors. Subarus fix was to put the wind down, open the door and apply a large upward pressure to the mirror. You will be bas...