Search found 1444 matches
- Thu May 04, 2017 7:03 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Once I get it setup right it will work fine bennie, just like the EA81 thermo circuits work fine. I'm just puzzled as to why it's not working with the EJ when it's pretty much the exact same setup as the EA using the same rad and thermoswtich plus circuit wiring (ignore my extra relay as that is not...
- Mon May 01, 2017 6:04 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Looking at the thermo switches online it looks like the thermo switch in my radiator isn't the standard Subaru one. It appears to be made for a Mitsubishi (TFS139, it has flat blade connector not the round one) and therefor it would be 85 on 80 off instead of 90 on 85 off like the Subaru one. This c...
- Mon May 01, 2017 5:53 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Relay has been checked. Thermostat has been kettle checked with IR thermometer. Also it's installed correct way up. Radiator is in good clean working order. Plenty of flow through it and no cold spots. It's also only a couple of years old. Radiator is well grounded. Fans run all the time, temp stays...
- Wed Apr 26, 2017 8:46 pm
- Forum: Engine, Gearbox and Diff
- Topic: Plastic speedo drive gear in gearbox 3.7 vs 3.9
- Replies: 1
- Views: 3189
Plastic speedo drive gear in gearbox 3.7 vs 3.9
This is something I should know but cannot remember, is the 3.9 diff ratio gearbox speedo gear smaller than the one in the 3.7 ratio gearboxes?
- Tue Apr 25, 2017 8:29 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Not sure if this would have an effect but here is my findings on the thermostats and thermo switch. EJ thermostat Dayco 77c OEM 78c EA81 thermostat Tridon 82c Wahler 82c EA81 thermo switch Tridon On 90c, off 85c I'm a bit puzzled how the EJ manages having the thermostat on the input side of the engi...
- Tue Apr 25, 2017 7:18 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
I did some more driving tests and left the car to get hot without the fans plugged in. Although it is running on only water at this stage the gauge was only half way between the running temp line and the over heat line (which the EA81 used to overheat at) before it started pushing steam out the radi...
- Mon Apr 24, 2017 8:22 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Thanks for the suggestions. I tested the switch in a pot of water on the stove awhile back and it appeared to be working perfectly fine. Switched on at around 90 degrees and off at 83 ish IIRC. The heater in the car works well, as normal as I can remember it. Ignore my wiring changes as I had been t...
- Sun Apr 23, 2017 9:06 am
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
I don't have an ECU. My conversion is a little bit different... I'm triggering a relay off the stock wiring using the radiator thermoswitch. Before I installed the relay I just used the stock wiring and it had the same issue. The temp doesn't get hotter than 100c in the coolant crossover at idle but...
- Sat Apr 22, 2017 6:58 pm
- Forum: Fitting EJ motors to MY & L series models
- Topic: Cooling fans staying on.
- Replies: 30
- Views: 23911
Cooling fans staying on.
I've swapped out to an EJ, I've kept the factory radiator, I have two fans mounted on the front of the AC condenser. I'm using the factory radiator thermo switch to operate both fans. When the gauge gets to about 3mm down from the middle line the fans kick in (the thermo sensor in the coolant crosso...
- Tue Mar 28, 2017 6:47 am
- Forum: South Australia
- Topic: U-Pull-It / Lonsdale...
- Replies: 116
- Views: 60166
- Mon Mar 13, 2017 7:49 am
- Forum: Forum Help Area
- Topic: Search result ends in Server error 500
- Replies: 1
- Views: 3017
Search result ends in Server error 500
Has anyone else noticed that heading to this site through a Google search result brings up a server error message?
- Sun Feb 19, 2017 9:27 pm
- Forum: South Australia
- Topic: U-Pull-It / Lonsdale...
- Replies: 116
- Views: 60166
- Tue Jan 17, 2017 5:39 pm
- Forum: South Australia
- Topic: U-Pull-It / Lonsdale...
- Replies: 116
- Views: 60166
- Mon Jan 02, 2017 1:52 pm
- Forum: South Australia
- Topic: U-Pull-It / Lonsdale...
- Replies: 116
- Views: 60166
- Thu Dec 29, 2016 4:09 pm
- Forum: Open Slather
- Topic: Fun and games - time to move
- Replies: 13
- Views: 6262
- Tue Dec 27, 2016 4:21 pm
- Forum: Open Slather
- Topic: Merry Christmas for 2016!
- Replies: 9
- Views: 4689
- Mon Nov 21, 2016 8:06 pm
- Forum: South Australia
- Topic: SA losing Subie enthusiasts
- Replies: 20
- Views: 18125
- Sat Nov 12, 2016 3:07 pm
- Forum: South Australia
- Topic: SA losing Subie enthusiasts
- Replies: 20
- Views: 18125
SA losing Subie enthusiasts
So in the past two months I've seen 3 main SA members on here either sell their Subaru or are selling them. what's going on people?! Anyone new on here to make up the numbers!?
- Sat Nov 12, 2016 2:00 pm
- Forum: For Sale
- Topic: Parting out 1990 Liberty in SA
- Replies: 13
- Views: 7834
- Sun Nov 06, 2016 8:48 am
- Forum: For Sale
- Topic: Parting out 1990 Liberty in SA
- Replies: 13
- Views: 7834