Page 1 of 1
Wheres the best place to find a Bull bar for an L series
Posted: Wed May 25, 2011 12:19 am
by Fatman69
Chasing a bull bar for my 89 sportswagon and cant seem to find one where is the best place to start looking
Posted: Wed May 25, 2011 12:20 am
by Fatman69
and yes I know bull bars are in Bull Pubs
Posted: Wed May 25, 2011 8:03 am
by sven '2'
Ebay, wreckers, on here.
They are easier and cheaper to come by these days - even a bumper replacement can be had for as little $50. (they used to fetch $650+ back in the day).
Posted: Wed May 25, 2011 11:21 pm
by sven '2'
Here is one with a Touring Wagon thrown in for free
Posted: Wed May 25, 2011 11:44 pm
by guyph_01
My place:) lol, but you should definitely have quite a few more over east:) just keep an eye out on ebay, gumtree etc
Posted: Fri May 27, 2011 8:02 pm
by Fatman69
Have been looking on ebay , yet to come across one but patience wins the race
would a brumby 82 - 92 bull bar fit a L series
Posted: Fri May 27, 2011 8:15 pm
by sven '2'
Short answer...no
Would take considerable re-manufacturing to fit.
Posted: Fri May 27, 2011 8:21 pm
by Fatman69
ok that solves that ? ,
Posted: Fri May 27, 2011 10:37 pm
by sven '2'
Off topic, but what happened re: Rolled a sherpa on the Bruce 6 times in 94 and survived .....?
Sounds most unpleasant
Posted: Thu Jun 02, 2011 12:50 am
by El_Freddo
sven '2' wrote:Off topic, but what happened re: Rolled a sherpa on the Bruce 6 times in 94 and survived .....?
Sounds most unpleasant
I'm keen to hear about this as well. Sounds like you're one lucky fella! You might just have the luck to win one of those auctions!
I've also heard that the ford courier bullbars fit the L's with a little modification. What modification I don't know - I've just heard this on the grapevine...
Cheers
Bennie
Posted: Thu Jun 02, 2011 8:39 am
by Green_eyed_liberty
i have one? but its not the "full replacment type" much the same as the one in El_Freddo's sig ^^^^ and you can have it for freeeee (located on the Gold Coast)
ohh and i fitted an L series bullbar to my Brumby.. just took a few more holes to make it look right haha