Page 1 of 1
Matching parts
Posted: Thu Nov 08, 2012 2:56 pm
by brado
Hi...Does anyone know what parts off a 87 L series will fit into either my 87 or 84 Brumby...I have a good L series but was thinking of giving it away ..just would rather take the parts if they work in the brumby..i.e Alt,starter....radiator..cheers..
Posted: Thu Nov 08, 2012 6:09 pm
by dfoyl
Interior light lens.
Yes, other parts fit but no net gain.
Posted: Thu Nov 08, 2012 6:35 pm
by steptoe
gearbox, engine, rear diff and diff hanger, seats at a pinch, tyre and rim, fuel
, carb and inlet manifold, exhaust Y pipe apparently too , just bigger bore
Posted: Thu Nov 08, 2012 7:01 pm
by TOONGA
Diff hanger will not fit, the "L" series is longer... I found out the hard way.
TOONGA
Posted: Thu Nov 08, 2012 9:31 pm
by steptoe
arr, the other diff hanger at the front of diff, not moustache bar ....at the back
Posted: Fri Nov 09, 2012 4:50 pm
by Silverbullet
Seats require serious mods to fit, ask me how I know
Posted: Fri Nov 09, 2012 8:24 pm
by steptoe
I know someone who did L seats into a Brumby and if it was too difficult at that stage in life, he would have thrown spanners, a tantrum, taught the neighbours more four letter words and likely left rubber up the driveway soon after. They went in OK, Mazda 626 1990 seats are a different story - I know from experience and two years of determination
When I first joined this forum (when the six star badged appeared on dinosaurs) there was talk of the EA82 dizzy mod to fit EA81 to get e instead of points
Posted: Sun Nov 11, 2012 1:59 pm
by El_Freddo
steptoe wrote:there was talk of the EA82 dizzy mod to fit EA81 to get e instead of points
There are EA81 units out there with the electronic module, but you can fit the EA82 dizzy with some mods - Tweety's just done this from what I've read on this supercharger mod thread
Cheers
Bennie