Greased brake pads!

LIFTED · Post by **LIFTED** » Tue Jun 25, 2013 10:49 am

I have to share the stupidity of this.

I recently bought a Forester(privately) and the front wheel hub bearing needed replacing it made the brakes rattle and made a loud noise.
When I first drove the car there wasn't much brake noise but I noticed they didn't seem to pull up very sharply.
Ok so I took the car round to RSR555 to change the hub with one I got from a wreckers. (and that's another story )
We found some clever person had put grease, yes GREASE! on the brake pads!
WHAT THA FLICK! unbelievable!:shock:

julian · Post by **julian** » Tue Jun 25, 2013 2:52 pm

Presumably to make them quiet???

Post by **TOONGA** » Tue Jun 25, 2013 6:50 pm

My guess is they were greased to stop the severe vibration they would've made with the stuffed hub

TOONGA

Wooster · Post by **Wooster** » Tue Jun 25, 2013 7:47 pm

Quite clever really, but what a Wan&^%

purp · Post by **purp** » Tue Jun 25, 2013 8:12 pm

Yeah, if done to stop a squeak they were a moron. If it was done to quiet a dodgy hub so they could sell it, that's pretty scummy.

steptoe · Post by **steptoe** » Wed Jun 26, 2013 8:18 am

nah, tis an old water repelling trick to improve braking in the wet , think I went to school with the former owner - he used to oil his bikes brake blocks for improved wet weather brakes

LIFTED · Post by **LIFTED** » Wed Jun 26, 2013 11:38 pm

Yep Toonga I think it was done for that reason to sell the car. He said he was a heavy machine truck eletrician. So he must have known about cars.

Rodeo4jake · Post by **Rodeo4jake** » Thu Jun 27, 2013 4:30 am

I've seen people put grease on the back side of brake pads when all the little shims & stuff are long gone. It's supposed to stop the pads rattling round in there. I used to order the shims & put them back in.