A few months back someone here said the Brumby tailgate and bed trim end caps were the same - I found a spare set of the tailgate caps and I don't believe this is correct :
Anyone have a photo of the bed trim caps ?
Brumby tailgate end caps q?
Brumby tailgate end caps q?
1989 Brumby - Shiny new red paint, stroked EJ20 phase 2 SOHC with Darton sleeves bored to EJ22, Wiseco high-compression pistons, Delta 2000 grind cams , EJ/XT6 5 stud with WRX 4/2 pots, 5-speed, 86 GTS seats and so much more.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
- steptoe
- Master Member
- Posts: 11582
- Joined: Thu Oct 06, 2005 10:00 am
- Location: 14 miles outside Gotham City
might be like when the XE Falcon sedan came out - some old fart told me they were the same mould as the Mercedes of the day ! Bwahahaha
I have a end cap of some sort....somewhere
pic should be in Bantums 3D printing, sitting on a blue chux cloth ...
showthread.php?t=26078&highlight=printing&page=3
top of page three
I have a end cap of some sort....somewhere
pic should be in Bantums 3D printing, sitting on a blue chux cloth ...
showthread.php?t=26078&highlight=printing&page=3
top of page three
- Bantum
- General Member
- Posts: 1923
- Joined: Sun Jul 29, 2012 4:30 pm
- Location: Northern Territory + QLD
- Contact:
Differences ...
Sorry I missed your earlier request for info ...
Some pictures :
Noted that they are different, but you can still use the side end cap on the tray as the profile is the same, just shorter.
Also have the clip for trim screws :
P.S. - I'm still working on 3D replacements for these & will post them up when done ...
( It might take a while though, as have a backload of other bits to do ... )
Cheers, Bantum ...
Some pictures :
Noted that they are different, but you can still use the side end cap on the tray as the profile is the same, just shorter.
Also have the clip for trim screws :
P.S. - I'm still working on 3D replacements for these & will post them up when done ...
( It might take a while though, as have a backload of other bits to do ... )
Cheers, Bantum ...
Thanks guys, that puts paid to the claim they were the same...
1989 Brumby - Shiny new red paint, stroked EJ20 phase 2 SOHC with Darton sleeves bored to EJ22, Wiseco high-compression pistons, Delta 2000 grind cams , EJ/XT6 5 stud with WRX 4/2 pots, 5-speed, 86 GTS seats and so much more.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Contact me for reproduction XT6 hubs...and EA82 rear discs.