Liberty Seats into A Brumby

RSR 555 · Post by **RSR 555** » Wed Feb 08, 2012 4:51 am

Tozzy wrote:Just did to my Brumby. I got the Liberty seats from Guyph.

Hey Steve.. aren't they WRX seats? they have the same floor plan bolt pattern but not the same (but very similar) rail-to-seat pattern.

I like Dane's way of just removing the bottom frame piece and swapping over. This means no mod to the rails and also keeps it as low as possible.

Brumby Kid · Post by **Brumby Kid** » Wed Feb 08, 2012 7:10 am

Tozzy,
That is a perfect pic, exactly what I needed!!!

Cheers Cam

Tozzy · Post by **Tozzy** » Wed Feb 08, 2012 8:23 pm

Glad to help.

It's a bit complicated with the drivers side as it had a lift seat in case you are a short A#$%se.

Can explain but take awhile.

Also just a bit of advice............don't use a rattle gun with a uni joint in a confined space like a Brumby cab. Apparently the 14mm socket tends to fly off if you accidently touch the trigger.

You will also need to cut off the side of the plastic door trim. I can send pictures of it as well if you like.

Just use a Stanley knife. I was a bit reluctant to cut them off but I recon the seats covered the missing bits.

Brumby Kid · Post by **Brumby Kid** » Wed Feb 08, 2012 8:30 pm

Yes please photo's would be great!

Tozzy · Post by **Tozzy** » Wed Feb 08, 2012 10:59 pm

Photos of the cut away parts of the side step kick panel.