Page 2 of 2
Posted: Wed Feb 08, 2012 4:51 am
by RSR 555
Tozzy wrote:Just did to my Brumby. I got the Liberty seats from Guyph.
Hey Steve.. aren't they WRX seats? they have the same floor plan bolt pattern but not the same (but very similar) rail-to-seat pattern.
I like Dane's way of just removing the bottom frame piece and swapping over. This means no mod to the rails and also keeps it as low as possible.
Posted: Wed Feb 08, 2012 7:10 am
by Brumby Kid
Tozzy,
That is a perfect pic, exactly what I needed!!!
Cheers Cam
Posted: Wed Feb 08, 2012 8:23 pm
by Tozzy
Glad to help.
It's a bit complicated with the drivers side as it had a lift seat in case you are a short A#$%se.
Can explain but take awhile.
Also just a bit of advice............don't use a rattle gun with a uni joint in a confined space like a Brumby cab. Apparently the 14mm socket tends to fly off if you accidently touch the trigger.
You will also need to cut off the side of the plastic door trim. I can send pictures of it as well if you like.
Just use a Stanley knife. I was a bit reluctant to cut them off but I recon the seats covered the missing bits.
Posted: Wed Feb 08, 2012 8:30 pm
by Brumby Kid
Yes please photo's would be great!
Posted: Wed Feb 08, 2012 10:59 pm
by Tozzy
Photos of the cut away parts of the side step kick panel.