Page 1 of 1
Faulty Codes
Posted: Sun Jul 06, 2008 7:33 pm
by iananita
Have 2 fault codes ej22, Cam angle sensor + coolant temperature sensor.
The timing is advanced. How? Plugs are good, leads are good.
Engine runs ok but pings under load + flat spot when accerelate hard.
Thoughts?
Posted: Sun Jul 06, 2008 7:43 pm
by chubby37
the timming is set by the ecu and if your cam angle sensor is playing up will throw your timming out..both of the sensors can be bought at subaru and are very easy to change over
Posted: Sun Jul 06, 2008 7:46 pm
by Matatak
Coolant Temp Sensor can also throw the Fuel/Air Mixture out, which if lean can make it Ping under load.
Also thought that Pinging is a reason these engines have Knock Sensors.
Posted: Sun Jul 06, 2008 7:50 pm
by chubby37
yeah but i think doing wierd stuff that they should not really do is a subaru thang....love them to death but they try your patience at times
cam angle sensor fault code
Posted: Mon Jul 06, 2009 6:54 pm
by stevonz24
hay guys havent bin on in ageers, bin busy fixinbg suby ofcorse. ive got a cam angle sensor fualt code coming up. could this b cambelt timing? the sensor looks alright. any thoughts wuld b much helpd ta
Posted: Mon Jul 06, 2009 9:38 pm
by AlpineRaven
Check and count how many flashes while you're in test mode and you'll be able to tell you what is wrong.
Cheers
AP
Posted: Fri Jul 10, 2009 2:56 pm
by iananita
I pulled the cam angle sensor out and cleaned all contacts. I tested it as per Haynes manual it was ok so I cleared code and has been fine since. Temp sensors was dead and needed replacing recently Knock sensor needed to be replaced.
When my timing belt was out a notch, motor ran rough but no cam angle code