Page 1 of 1
outback tappet cover gasket
Posted: Wed Nov 18, 2009 8:46 pm
by camo85
does anyone know can the tappet cover gaskets be changed on and subaru outback engine while the motors is still in the car
Posted: Wed Nov 18, 2009 9:15 pm
by Gannon
In a Gen2 with its DOHC EJ25, probably not.
In a Gen3 with the SOHC EJ25, maybe. It might involve undoing the engine mounts and lifting the engine a few inches
Posted: Thu Nov 19, 2009 5:02 am
by AlpineRaven
i might be wrong, i don't know about sohc, i think you can change it while its in car.
Based on EJ22 You can change the gaskets while in car, without moving anything. I suspect EJ25 SOHC should be the same. But with DOHC it might be more complicated?
Cheers
AP
Posted: Thu Nov 19, 2009 6:13 am
by rob83ke70
bit fiddly i'd imagine.... I've done plugs a few times on dohc and h6 engines, I reckon anything is possible with patience.
The covers are aluminium alloy aren't they? when they are off you should polish them.... I know nobody will see them but its just a fun thing to have shiny shiny mirror finish bits on your engine lol.
Robert.
Posted: Thu Nov 19, 2009 7:28 am
by AlpineRaven
rob83ke70 wrote:bit fiddly i'd imagine.... I've done plugs a few times on dohc and h6 engines, I reckon anything is possible with patience.
The covers are aluminium alloy aren't they? when they are off you should polish them.... I know nobody will see them but its just a fun thing to have shiny shiny mirror finish bits on your engine lol.
Robert.
I have lol.. Yeah you can polish it up. Its a pain in the arse job bec by end of the week it needs polishing again. Same with me i also did a diff cover as well, didn't stay polished.
Cheers,
AP
Posted: Fri Nov 20, 2009 9:37 am
by bobbyjimmy
Can do it in the car.
The very rear, lower bolt on the LH side is the biggest PITA to get to out of the lot of them. Easiest to get it from underneath and you'll need a spanner as a socket won't fit between the cover and chassis rails.
Posted: Sun Nov 22, 2009 12:07 am
by camo85
thanks for replys how do i tell dohc to sohc can you tell by engine no. ej25DNWDJA
Posted: Sun Nov 22, 2009 6:01 am
by AlpineRaven
camo85 wrote:thanks for replys how do i tell dohc to sohc can you tell by engine no. ej25DNWDJA
check this thread -
showthread.php?t=14495&highlight=dohc
I have posted two photos - that will give you best idea of what engine you have.
Cheers
AP
Posted: Mon Nov 23, 2009 8:45 pm
by wrxer
for sure rh dohc is in car ok. and the lh side is further forward so has more room. should be ok