Rear drive shaft rebuild

Get the most out of your Engine / Gearbox with these handy hints ...
Post Reply
User avatar
JP147
Junior Member
Posts: 239
Joined: Tue Dec 03, 2013 5:01 pm
Location: Port Adelaide, SA

Rear drive shaft rebuild

Post by JP147 » Tue Mar 01, 2016 7:14 pm

I remember this being discussed earlier but I can't find the thread.

Where to get new CV joints and boots for rear shafts? I have 3 rear shafts and none have good joints on them.
Image
Top
User avatar
TOONGA
Elder Member
Posts: 5335
Joined: Sat May 30, 2009 10:15 am
Location: Australind closer to where they divided by zero
Contact:
Contact TOONGA

Post by TOONGA » Thu Mar 03, 2016 12:20 pm

suzukisuper on ebay might be able to source them

your best bet is to find someone wrecking a newer brumby and get them that way.

TOONGA
Image
PJ Gone but not forgotten
JETCAR AKA the sandwedge Rusted in pieces
Top
User avatar
JP147
Junior Member
Posts: 239
Joined: Tue Dec 03, 2013 5:01 pm
Location: Port Adelaide, SA

Post by JP147 » Sat Mar 05, 2016 6:00 pm

The main problem seems to be that the joint on one end of the shafts is not sealed like the other, and it always seems to get water and dirt in it after a while. I would rather not have to constantly buy new shafts. Is it possible to put two sealed joints on the one shaft? And could front inner joints maybe be used on the rear?
Image
Top
Post Reply

Return to “Engine, Gearbox and Diff”