The AUSubaru.com.au Forums

Trying to get the cam pulley of the left hand head[ej22].Have tried a 1/4extension bar and 10mm socket holding the pulley still and a breaker bar on the bolt holding it on ,this resulted in the bolt that holds the cover on bending.Tried a old cam belt wrapped around and locked off ,1m long breaker and still it won't move.This thing won't budge.The head is still on the motor.
Any one know any other tricks?

get a puller then yank it off and if you break it thne guess ull have to buy a new one

OOOps Should of said a can't get the bolt off that holds the pulley on.

haha yer that helps..i was kinda wondering wt the cambelt was really used for and why you were bending bolts lol..

neway have u tried a rattle gun..or if you dont have one then a breaker bar and smack it with a decent hammer to try n shock it into coming undone kinda like a rattle gun would do

Rattle gun

u no tyre shops use them and n other workshop to un do really tight bolts there usally air oppersted but can get cordless ones

but if u can move it with a breaker bar dont no if it will help u

If push comes to shove try an easy-out (especially if you snap the bolt) - the trick will be to get the drill in there to drill a hole in the remaining piece of bolt...

thanks guys its off.My super chump rattle gun wouldn't budge it.Used a bit of penitrine and a ring spanner.

You should have borrowed my SuperChump rattler i think its a freak one as its still going after 8 years of service and abuse