EJ swap - no spark ??

LongtimeAddict · Post by **LongtimeAddict** » Wed Sep 17, 2008 8:32 pm

Ha !!!! Why didn't I think of that ? I used to do that with the EA82 ecu, does the ej ecu still have the same setup ?

Thankyou thank you !

brm81t · Post by **brm81t** » Thu Sep 18, 2008 8:23 am

Hi wiring is so frustrating one thing you could try is plugging the dash into the loom. there are a few things built into dash electronics that might be causing prob.

shuffbag · Post by **shuffbag** » Thu Sep 18, 2008 1:09 pm

ok so if you still don't have spark, you should check out this write up (if you haven't allready)
http://http://www.d.umn.edu/~alex0219/Subaru/EA2EJ.pdf
page 22, around the ingnition relay is where i think i got spark. this write up is all i had when i did my swap and i had done nothing electrical to any other car in the past.

LongtimeAddict · Post by **LongtimeAddict** » Thu Sep 18, 2008 2:40 pm

Thanks Shuffbag. Thats the one i've been using as well. I think I need to pull it all apart and start over, I have obviously done something wrong, so back to square one.

:(

Suby Wan Kenobi · Post by **Suby Wan Kenobi** » Thu Sep 18, 2008 8:03 pm

Back to basics

The diode under the dash hasnt been disconnected?

The ignitor is plugged in?

The brown relay is clicking?

The AUSubaru.com.au Forums

EJ swap - no spark ??

argh