97 WRX cam/crank/knock wiring

Outback bloke · Post by **Outback bloke** » Mon Feb 20, 2006 7:41 pm

Does any one have or know where I could find a schematic layout for the 97 wrx cam, crank and knock sensor. It is the plug at the back of the engine that I am needing to know what goes where.

Pete · Post by **Pete** » Mon Feb 20, 2006 8:35 pm

I have soft copies of the 02 WRX manual if that is of any help ?

Outback bloke · Post by **Outback bloke** » Mon Feb 20, 2006 8:43 pm

Thanks for the offer but they are different. I have 95, 99, 02, and 04 diagrams and none of them match the 97.

Pete · Post by **Pete** » Mon Feb 20, 2006 10:23 pm

Can you get enough access in the sensor conn's to fish around with an audible multimeter to figure out the pin outs or do you need something specific like a conn Part number ?

PeeJay · Post by **PeeJay** » Tue Feb 21, 2006 10:09 am

I have got some that claim to be 97 Legacy, not sure if they will help or not, but I sent them anyway.

vincentvega · Post by **vincentvega** » Tue Feb 21, 2006 11:27 am

surely Al has what your after?

Craigus · Post by **Craigus** » Tue Feb 21, 2006 8:00 pm

I'm sure that I'm missing the point of the question, but can't you actually physically see which wires go to which sensors ? What specifically do you need to know?

jzk25 · Post by **jzk25** » Tue Feb 21, 2006 8:51 pm

Is this for that harness you got from Tim?

Jeff · Post by **Jeff** » Sat Feb 25, 2006 3:54 pm

Brett i have several 97/98 wrx manifolds with harnesses attached your welcolm to come and work out what you need
Jeff

Outback bloke · Post by **Outback bloke** » Sat Feb 25, 2006 4:54 pm

All done now. Car starts so it must be wired in properly.