Guys.. help
Was doing a simple globe change when pop ting ting ting, there goes my spring and heres the reason why. Normally theres a little screw that goes into the blown out hole with the screw head holding the spring in place.
What are my options? Im thinking remove the headlight and drill a pilot hole through the backside then run a longer screw right through with a big washer to hold the spring in the groove.
2005 Outback headlight clip snapped
- Kustomchris
- Junior Member
- Posts: 122
- Joined: Sun Sep 02, 2012 3:02 pm
- Location: Mooroolbark, VIC
- 60766244
- Junior Member
- Posts: 586
- Joined: Fri Nov 09, 2012 3:32 pm
- Location: Kalamunda, Western Australia
Duct tape + more duct tape until you can get a replacement part. I've done this on a few vehicles now...
Otter the 2004 Outback with all the fruit.
Possible Improvements: Rigid 12db Phone Aerial Fitted, Air-compressor w/ Hose & Air-Tank, Jerry Holders, Lift, Nudgebar and Spots?
|| Ausubaru Wiki: New AUSubaru Wiki, About the Wiki || My Ex, Maple the Brumby, Rack, Lift Kit, Raptor-Liner Tray || Shed: Benches ||
Possible Improvements: Rigid 12db Phone Aerial Fitted, Air-compressor w/ Hose & Air-Tank, Jerry Holders, Lift, Nudgebar and Spots?
|| Ausubaru Wiki: New AUSubaru Wiki, About the Wiki || My Ex, Maple the Brumby, Rack, Lift Kit, Raptor-Liner Tray || Shed: Benches ||