ej20TT loom question

Radeon · Post by **Radeon** » Mon Jul 10, 2006 8:49 pm

Thanks a lot mate, your help has been great. Im so pleased to hear i dont have to swap looms!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

vincentvega · Post by **vincentvega** » Mon Jul 10, 2006 9:13 pm

speaking of torque cut signals Al... did you get my email a while back?

mattims · Post by **mattims** » Tue Jul 11, 2006 7:20 am

im pretty sure all of the automatic stuff is there on the ecu but is simply disabled (either be the lack of tcu or ground one of the wires). But somehow my computer does report its a manual to scanning software. But then i guess you could be right because i have had alot of problems with it (detonation, very inconsistent power, rod bearing failure) that could quite possibly all be related to a confused computer.

Mine is a factory manual though so i guess id be at least a bit upset if not suprised if subaru didnt bother to set it up right.

jzk25 · Post by **jzk25** » Tue Jul 11, 2006 7:50 pm

vincentvega wrote:speaking of torque cut signals Al... did you get my email a while back?

Haven't seen it? Can you resend it?

vincentvega · Post by **vincentvega** » Tue Jul 11, 2006 10:23 pm

Al check your PM