gen 1 lowering

scotty bmx · Post by **scotty bmx** » Tue Aug 10, 2010 6:54 pm

hey, im looking for some ideas of what a cheap way to lower my 1990 model liberty wagon would be. i have some photos of where it sits now and i would like it at this height, but maybe a little higher. we chopped the springs that are in it now due to i know for sure that im going to put new ones in. one of my mates said i can put wrx shocks and springs in and it will be cheaper. is this true? if so, how much?
any help would be good

spike · Post by **spike** » Tue Aug 10, 2010 7:11 pm

you want cheap??

cut the springs, drill the shockers.

OH you wanted legal, sorry bout that =)

scotty bmx · Post by **scotty bmx** » Tue Aug 10, 2010 7:13 pm

yer, iv already cut as i said but im talkin lik $50 cheap, im talking lik cheaper than $500 for springs n chocks,

spike · Post by **spike** » Tue Aug 10, 2010 8:25 pm

your not goign to get WRX suspesion for that.
cut them some more is your best option, only way you can get them for 50$

AlpineRaven · Post by **AlpineRaven** » Tue Aug 10, 2010 9:51 pm

Dont be idiot.. how much lower are you gonna go down? If i were ya, get it done legally.
Cheers
AP

scotty bmx · Post by **scotty bmx** » Wed Aug 11, 2010 8:39 pm

well i run 18" wheels so all i want to lower it is the maximum 5cm for nsw law.
iv been looking at a set of lovells springs. are they good or bad?
or is there any other types i can buy because kings dont make them for the rear of my model.