1.8L UEL headers??

VS3800 · Post by **VS3800** » Thu Jun 18, 2009 8:13 pm

Does anyone know where i could get some unequal headers for my 1.8L?

Heard that they came on the early 1st gen legacys?

Im struggling to find anything to fit the 1.8...

H-top · Post by **H-top** » Mon Jul 06, 2009 9:56 pm

G'day
What engine are they for? Ej18 i assume?
Most i've seen factory for ej's cat inclusive and essentialy unequal length.
Are you after the boxer beat due to being uneven?
I was under the impression that the beat was from the 1 3 2 4 firing order -awaiting correction-
I roll with even length strags and have that wonderous note and more torque, it's all up up to the owner or space restrictions
Any exhaust shop could knock a custom set up for a in a few hours.
But if you do in custom, insist on mandrel bends, after spending your hard earned bikkies, you don't want a MORE restrictive system through shitty crushed bends (due to minimal working space and tight angles) instead of glorious smooth mandrel's mmmmm..... Mandrel's -drools-

Just my two bob worth

Cheers

YouTube · Post by **El_Freddo** » Fri Jul 10, 2009 5:10 pm

I'm sure your subi already as them with the stock exhaust system unless its up near the post 2000/2004 end of the market... What I think you need to do is open up the exhaust a little to get rid of the sound muffling system that hampers the subi beat...

This is a 2.5 outback (I think) with equal lenght extractors and an open exhaust - I think it sounds the part!

Cheers

Bennie