Page 1 of 1
Retread Mud Tyres
Posted: Sat Jul 14, 2012 7:34 pm
by alang
Just interested to see if anyone has used the retreaded mud tyres on their subaru before seen this lot on ebay.
http://www.ebay.com.au/itm/4-x-NEW-OUTB ... 322wt_1163
Posted: Sat Jul 14, 2012 8:02 pm
by d_generate
I wouldn't hesitate using them at that price, nearly every semi trailer you see is sitting on them and back in the olden days I used them on my S Series Valiant without a problem.
Posted: Sat Jul 14, 2012 8:06 pm
by purp
And 13s!
I am interested.
Posted: Sat Jul 14, 2012 8:11 pm
by Brumby Kid
At the standard brumby size.
175/75
Posted: Sat Jul 14, 2012 8:38 pm
by alang
has them in a 14" cheaper again said to send post code for freight cost
http://www.ebay.com.au/itm/4x-NEW-ALL-T ... 397wt_1163
Posted: Sat Jul 14, 2012 9:22 pm
by TOONGA
just make sure to put inner tubes in them
TOONGA
Posted: Sun Jul 15, 2012 2:02 am
by d_generate
Inner tubes can overheat at low pressure, I'm sure all cases are checked thoroughly for damage in the manufacturing process.
Posted: Sun Jul 15, 2012 8:54 am
by Alex
Is it just me or do they have stuff all tread? The tread blocks seem a bit shallow?
Sent from my HTC Velocity 4G using Tapatalk 2
Posted: Sun Jul 15, 2012 7:18 pm
by revmax
they are only 13" tyres remember.
Posted: Sun Jul 15, 2012 7:32 pm
by thunder039
i would buy them no worries, wish they made a tyre like that for the forester!
Posted: Sun Jul 15, 2012 7:48 pm
by alang
thunder039 wrote:i would buy them no worries, wish they made a tyre like that for the forester!
what 16" $359 for four
http://stores.ebay.com.au/Home-of-OUTBA ... 4340.l2563
Posted: Sun Jul 15, 2012 7:57 pm
by thunder039
yes but they wont fit with my current set up
Posted: Sun Jul 15, 2012 8:07 pm
by B00sting
very cheap, worth it for the price IMO.
Posted: Sat Jul 28, 2012 5:37 pm
by jakebrumby
did you end up buying them? looking at a set for my brumby, wondering how they went?
Posted: Sun Jul 29, 2012 1:16 pm
by alang
no i didn't not ready for tires yet still doing cv and lower ball joints and front brakes before moving to the rear
Posted: Mon May 20, 2013 8:32 am
by GunFactory
Has anyone on the forum actually run these? Very interested in how they perform.