Amazing video.

BRUMBERTY · Post by **BRUMBERTY** » Thu May 10, 2007 10:59 am

http://www.youtube.com/watch?v=QsmiIeAkE-o&NR

I SO want a 5 axis CNC mill now!
I probably will need a very clever Japanese man too...hmm

mattims · Post by **mattims** » Thu May 10, 2007 8:45 pm

actually there reasonably easy to program....

all the tools required to do this are expensive though. And accuracy is hard to get on cheap machines

julian · Post by **julian** » Fri May 11, 2007 9:13 am

Best youtube video i have ever seen, thanks.
Out of interest what is the cooling fluid/lube they are using?

YouTube · Post by **El_Freddo** » Fri May 11, 2007 1:48 pm

That is insane... I pity the poor bloke who stood there and filmed the whole process to get what we've just seen.

Wonder what block it was - chev 350 etc.

FROG · Post by **FROG** » Fri May 11, 2007 4:44 pm

i think i saw some where thatit was e ferrari block not sure tho.....

the coolant is usually an oil base that stinks when you get it on ya ...brings back some bad memories from my apprenticeship....