Page 1 of 1
wanted: EA81 short block. alive or wounded.
Posted: Thu Feb 21, 2013 11:25 am
by Subydoug
Hi,
Looking for an ea81 block and heads. Doesn't need to be running but id prefer it in at least ok condition. Can't see anything in the for sale section or gumtree. Anyone around Perth have one they'd be willing to let go?
Regards
Doug
Posted: Thu Feb 21, 2013 1:49 pm
by steptoe
holding hand up , as guilty to thrown that stuff out !
Posted: Thu Feb 21, 2013 6:49 pm
by scoobymine
I think RSR555 might be able to help. he's in Rockingham (good bloke too)
Posted: Thu Feb 21, 2013 6:54 pm
by scoobymine
Try RSR555, he's in Rockingham.
Posted: Thu Feb 21, 2013 7:49 pm
by niterida
steptoe wrote:holding hand up , as guilty to thrown that stuff out !
Yeah I just threw out the engine that was in front of the box that Subydoug got from me......ooops
Posted: Fri Feb 22, 2013 8:43 am
by Subydoug
Haha, fancy that. No stress, Im sure someone has one. I dont need one, just thought it'd be easier to tinker with and have no down time on the wagon.
Regards
Doug
Posted: Fri Feb 22, 2013 11:14 am
by RSR 555
Yes Doug, I have 1/2 dozen lying around everywhere. If you want to have a look at one, just let me know.
Posted: Sat Feb 23, 2013 4:38 pm
by suba2
Subydoug wrote:Hi,
Looking for an ea81 block and heads. Doesn't need to be running but id prefer it in at least ok condition. Can't see anything in the for sale section or gumtree. Anyone around Perth have one they'd be willing to let go?
Regards
Doug
I have a good set of heads that have been recondtioned but I'm in Sydney could send by courier
Posted: Sat Feb 23, 2013 6:38 pm
by TOONGA
Not only does Paul have a herd of EA81's he has a set of Fuel injected heads for a turbo or fuel injected motor. I just need to bring them back to Perth as I thought some one was going to buy them but that fell through.
TOONGA
Posted: Sun Feb 24, 2013 8:11 pm
by Subydoug
Got a motor off Paul, thanks a bunch, exactly what I was chasing.
Thanks for the offer Suba2
Regards
Doug
Posted: Sun Feb 24, 2013 9:51 pm
by RSR 555
No worries Doug and great to meet you.
Can't wait to see the build thread
Posted: Sun Feb 24, 2013 10:22 pm
by Subydoug
HA! build thread?? Its gonna be a while yet. Doing this as the pay cheques roll in
. Will start stripping it down and cleaning it up soon though....Deck the heads......new valves.....new 3 or 5 angle valve seat.....some general modern-izing
.
Regards
Doug
Posted: Sun Feb 24, 2013 10:29 pm
by RSR 555
Stop teasing us
I'll be watching out for it, I have a very large soft spot for them