EA82 distributor set up
Posted: Sun Jun 26, 2011 11:24 am
watch this space
Uploaded with ImageShack.us
The ***ALL NEW*** AUSubaru.com.au Forums
One of Australia's original and top performing Subaru sites. Come and have a look and find out why so many people enjoy this site. ***THIS IS A NEWLY DEVELOPED VERSION, NOW ONLINE SINCE SEPTEMBER 2018*** New site address: www.ausubaru.com.au !
https://ausubaru.com.au/
EA82 distributor set up
Page 1 of 1
Posted: Sun Jun 26, 2011 11:25 am
Posted: Sun Jun 26, 2011 11:28 am
At zero (TDC) for #1 the cut mark pointed to bottom of tooth directly above big hole, move by one tooth bottom and is set for 20dBTDC for turbo
If you want ten degrees for carby maybe just halfway so lines up with top of tooth
Uploaded with ImageShack.us
If you want ten degrees for carby maybe just halfway so lines up with top of tooth
Uploaded with ImageShack.us
Posted: Sun Jun 26, 2011 11:30 am
Posted: Sun Jun 26, 2011 11:31 am
You'll just make out my feeler gauge to the left, measuring gap at 25 thou
This is how dizzy looks when engine at 20dBTDC, the cam wheel one tooth off mark (but timed correctly)
Uploaded with ImageShack.us
This is how dizzy looks when engine at 20dBTDC, the cam wheel one tooth off mark (but timed correctly)
Uploaded with ImageShack.us
Posted: Sun Jun 26, 2011 11:32 am
Posted: Sun Jun 26, 2011 11:34 am
Posted: Sun Jun 26, 2011 11:42 am
I have done a few like this on install and the baby has fired first up each time just needing a timing light for accuracy once running. Has helped a few others this way as well
NOTE, was for my EA82T 3 plug dizzy set at 20, NOT carby
NOTE, was for my EA82T 3 plug dizzy set at 20, NOT carby