Strut tops plans and measurements

brumbybear · Post by **brumbybear** » Wed Jun 02, 2010 12:10 pm

Im trying to find diagrams of strut extensions for my brumby cause a mate of mine wants to have a go at making some up.... Does anyone out the have diagrams and plans for making them??

Cheers Lasty

spike · Post by **spike** » Wed Jun 02, 2010 6:46 pm

yes we do...............
no you cannot have them
if hes good weld the holes and file em out
sorrry.

brumbybear · Post by **brumbybear** » Wed Jun 02, 2010 9:45 pm

thats ok... he is just in same boat as me and looking for a 2nd hand lift kit and cant afford to by a brand new one so he was going to have a go at making some if he could get some plans to go off... oh well we shall keep looking for a couple of 2nd hand lift kits...

cheers Lasty

vincentvega · Post by **vincentvega** » Wed Jun 02, 2010 10:18 pm

spike wrote:yes we do...............
no you cannot have them
if hes good weld the holes and file em out
sorrry.

what is the point of this post?

brumbybear - 7mm of offset per inch of lift rings a bell... but thats just going form my dodgy memory

spike · Post by **spike** » Thu Jun 03, 2010 9:19 am

ahhh sorry you want lifted strut tops?
not camber tops?? sorry mistaken then yeah i cant help

and sorry about my previous post was in a very foul mood

brumbybear · Post by **brumbybear** » Thu Jun 03, 2010 9:40 am

haha its all good spike.....vincent it sounds about right 7mm...