Page 1 of 1
Strut tops plans and measurements
Posted: Wed Jun 02, 2010 12:10 pm
by brumbybear
Im trying to find diagrams of strut extensions for my brumby cause a mate of mine wants to have a go at making some up.... Does anyone out the have diagrams and plans for making them??
Cheers Lasty
Posted: Wed Jun 02, 2010 6:46 pm
by spike
yes we do...............
no you cannot have them
if hes good weld the holes and file em out
sorrry.
Posted: Wed Jun 02, 2010 9:45 pm
by brumbybear
thats ok... he is just in same boat as me and looking for a 2nd hand lift kit and cant afford to by a brand new one so he was going to have a go at making some if he could get some plans to go off... oh well we shall keep looking for a couple of 2nd hand lift kits...
cheers Lasty
Posted: Wed Jun 02, 2010 10:18 pm
by vincentvega
spike wrote:yes we do...............
no you cannot have them
if hes good weld the holes and file em out
sorrry.
what is the point of this post?
brumbybear - 7mm of offset per inch of lift rings a bell... but thats just going form my dodgy memory
Posted: Thu Jun 03, 2010 9:19 am
by spike
ahhh sorry you want lifted strut tops?
not camber tops?? sorry mistaken then yeah i cant help
and sorry about my previous post was in a very foul mood
Posted: Thu Jun 03, 2010 9:40 am
by brumbybear
haha its all good spike.....vincent it sounds about right 7mm...