wheel stud adaptor plates

vidler · Post by **vidler** » Sat Feb 25, 2006 9:18 pm

found a local joint that makes them. $500 for a set of 4

its swan tyre and rim service

9242 7555 in osborne park

coupe · Post by **coupe** » Sun Feb 26, 2006 9:56 am

Hey Jay
Is that in a 5 or 4 stud configeration.
Cheers Pete

wildhorse · Post by **wildhorse** » Sun Feb 26, 2006 10:16 am

I can get you 4/100 pcd plates for 350 and postage

vidler · Post by **vidler** » Sun Feb 26, 2006 3:03 pm

they can make them 2 whatever you want... i want 140x4 to 114.3x5 to suit rav 4 wheels

85wrx · Post by **85wrx** » Mon Jun 19, 2006 5:35 pm

With these new pcd for the hubs what is actually done to complete this? Are there any photos of the front and rear hubs with this completed? What is the legalities with these being engineered? I am interested in talking to people that have used this.

Does anyone know if the 2wd rear hubs off a liberty will fit onto the rear 2wd stub axle on an MY coupe?

wildhorse · Post by **wildhorse** » Mon Jun 19, 2006 8:59 pm

with the 4/100 pcd plates(same stud pattern as Mitsibishi lancer and nissan pulsar), they are drilled inside the original holes and the original studs then pressed into these holes. the fronts on my ute have been trimmed in diameter down to 140mm but the backs weren't. I also had the faces machined to ensure the lancer stud pattern spiggot would fit onto the hub correctly. i went with lancer due to the ofset being very very close the original rims