Phantom gripp

Get the most out of your Engine / Gearbox with these handy hints ...
Post Reply
User avatar
Brumby Boy
Junior Member
Posts: 594
Joined: Sun Oct 16, 2005 10:00 am
Location: Townsville, Queensland, Australia

Phantom gripp

Post by Brumby Boy » Thu Feb 07, 2008 6:48 pm

Where can i get a front phantom grip (or any other type) lsd for an l series 5sp dr box??
Long live the 1990 Subaru Brumby 2" lifted and soon to be mig locked
RIP 1992 Brumby

http://www.cardomain.com/ride/2507954
http://www.myspace.com/brumby_boy

few self-respecting ricers would spend the time to modify a Daewoo.

Image

User avatar
90brumby
General Member
Posts: 1178
Joined: Mon Jan 29, 2007 10:58 pm
Location: Perth w.a

Post by 90brumby » Thu Feb 07, 2008 8:03 pm

i read on usmb that all the front diffs were the same its in there somewhere so u can run a diff from any model suby in the L box
The New Owner Of hatchie
A 00 outback for doner car
2 door wrx being restored

owned plently of other subis before

User avatar
Matatak
Senior Member
Posts: 2393
Joined: Fri May 04, 2007 8:06 pm
Location: Gnangara next to pines

Post by Matatak » Thu Feb 07, 2008 8:04 pm

all the front 5 speed diffs are the same. (not the 4speeds lol)

but yer i read that to on USMB.

and u can find front LSD's by searching on web i guess.
Image
Wagon is no longer....:(

The Subaru Wacky Workshop
-All About the WA Boys :D

User avatar
AndrewT
Senior Member
Posts: 4777
Joined: Tue Oct 04, 2005 10:00 am
Location: WA
Contact:

Post by AndrewT » Thu Feb 07, 2008 8:08 pm

Pretty sure you can only get front LSD setups in some very expensive STI WRX gearboxes. You'd likely pay more than the value of your entire Brumby and then have to install it too....if you can actually find one forsale.

User avatar
Matatak
Senior Member
Posts: 2393
Joined: Fri May 04, 2007 8:06 pm
Location: Gnangara next to pines

Post by Matatak » Thu Feb 07, 2008 8:21 pm

some of the aftermarket ones were kind of reasonable as far as i knew.
Image
Wagon is no longer....:(

The Subaru Wacky Workshop
-All About the WA Boys :D

User avatar
Jack
Junior Member
Posts: 302
Joined: Fri Dec 16, 2005 10:00 am
Location: Brisbane
Contact:

Post by Jack » Thu Feb 07, 2008 8:32 pm

I think the Liberty B4 had a factory fitted front LSD.

Image

:)
1999 Outback (some mods)
1989 Brumby (more mods)

Image

Subaru - Symmetrical All-Wheel Drive

User avatar
bluesteel
Junior Member
Posts: 892
Joined: Wed Oct 05, 2005 10:00 am
Location: Hobart, Tasmania

Post by bluesteel » Thu Feb 07, 2008 9:16 pm

pich one of the 5mt box's in here with a helical lsd and pull the front diff centre out of it, or there is a range of aftermarket items as well

Kaaz, Cusco, STI, Torsen, they start from aroung $1500 bucks new
Image

User avatar
Phizinza
General Member
Posts: 1444
Joined: Mon Oct 10, 2005 10:00 am
Location: SA
Contact:

Post by Phizinza » Thu Feb 07, 2008 11:19 pm

Seen a couple of STi front VLSD's and aftermarket LSD's that used to be fitted to WRX's on ebay. They go for around $600-$1500 secondhand depending on what.

I wouldn't put a phantom grip in a gearbox. In the rear diff, yeah fine. But in the front where it will chew itself up and the bits run through all your gears, that doesn't sound nice.
Owned - 89 Brumby, 83 Wagon, 83 Leone 4WD Sedan, 83 Touring Wagon, 99 Outback
Own - 87 Brumby, 93 Liberty, 09 Forester
Offroading Subarus Facebook Page


User avatar
brumbyrunner
General Member
Posts: 1743
Joined: Mon Apr 10, 2006 10:00 am
Location: SEQ

Post by brumbyrunner » Fri Feb 08, 2008 7:30 am

I'm got a Torsen LSD for the front diff in my race car. They tell me they're not much good if you lose all traction to one wheel (like lifting it in the air) but I've really only got it to protect the box. Might not be enough, we'll have to wait and see. For low speed off-roading you may be better off with a clutch-pack or plate-style LSD. The downside is the heavier it is (better it works) the greater impact it will have on your steering.
Search ebay, rexnet, rs, and any other subie forums.
Settlement Creek Racing

User avatar
mattl200
Junior Member
Posts: 324
Joined: Sat Oct 08, 2005 10:00 am
Location: NW Tasmania

Post by mattl200 » Sat Feb 09, 2008 8:54 pm

didnt think 3.7/3.9 ring gear would bolt to a 4.11 or 4.44 front center
someone correct me if im wrong
- 92 brumby, ej22, MT5AWD, lseries low range, centre diff lock, glf5 dash, 5 stud conversion
lifted 3" front 2" rear all rolling round on 27" khumo Kl71's
more in progress ie:adaptronic ecu and sc14 supercharger

User avatar
stamp_licker
General Member
Posts: 1066
Joined: Wed Oct 05, 2005 10:00 am
Location: Kallangur.Bris North

Post by stamp_licker » Sun Feb 10, 2008 9:08 am

From Phantom grip.Do a bit of a search ,i seen one that was homemade copy of the phantom grip.Forest rangers forrester had a l series box pt box with phantom grip locker up front.
[SIGPIC][/SIGPIC]aka the_postie
Building a hardcore postie:D

Post Reply

Return to “Engine, Gearbox and Diff”