Its Alive

90brumby · Post by **90brumby** » Wed May 14, 2008 9:33 pm

the brumby is alive again it got a exhaust today n ive just been for a quick drive n far out its fast
its got a few teethin issues but i will get it there also needs thermo fans, i wanna put in oil and temp guages engine stay rod and a few other bits n pices

tthe only semi major issue i have is that it surges a bit under load some times but then ffor no reason its all good again n when its good it hammers so im not quite sure wat is causin this yet but i will find out

the exhaust mob reckon its fairly high but i dono i think i must b use to it now

but i have very limited net use atm but i will keep a close eye on the board anyway

Matatak · Post by **Matatak** » Wed May 14, 2008 9:35 pm

Yay

did u ever get frotn shafts for it?

EJ goes nice aye

Time for pictures

90brumby · Post by **90brumby** » Wed May 14, 2008 9:40 pm

ye it now has complete lib suspenion Front includin lower control arms and rear impressa drive shafts lib steering colum n rack lib crossmember RS turbo brakes n big lift blocks in the front and rear

BrennyV · Post by **BrennyV** » Thu May 15, 2008 11:38 am

thats wikkid mate!! so you be up to take her to this pines this sat? gonna crank a day run

AndrewT · Post by **AndrewT** » Thu May 15, 2008 2:18 pm

Awesome Tristan, can't wait to see it! The surging might just be a teething problem that will sort itself out once you put a few kms on it. They are always a bit grumpy after waking up from a conversion

btw I still want that lift kit off you!

Subafury · Post by **Subafury** » Thu May 15, 2008 7:19 pm

good stuff mate- the brumby is finally ressurected. cant wait to see it in the flesh!

TW83 · Post by **TW83** » Fri Jul 18, 2008 2:23 pm

I had pretty aggresive intermittent surging as well. Turned out to be the plug leads werent pushed on tight enough. They needed a huge amount of force to get them to click on. Also replaced the plugs.

vincentvega · Post by **vincentvega** » Fri Jul 18, 2008 3:04 pm

where did you bolt the control arm mounts to??? the ones that bolt up to the body.

D3V1L · Post by **D3V1L** » Fri Jul 18, 2008 3:09 pm

tristans brumby is extremely custom:P

all special made brackets and all that crap..too hard to explain...need pictures and talking face to face to explain it:P

ill try convincing him to get some pics on the net of it

dave

Matatak · Post by **Matatak** » Fri Jul 18, 2008 7:59 pm

theres pics he posted up for andrewT at sometime i think. around somewhere

AndrewT · Post by **AndrewT** » Sat Jul 19, 2008 11:49 am

I was going to link those but they were before the Liberty engine crossmember was installed so I'm tipping it was changed around again.